Description

Shoda CNC Router 1998 Double Table 5 x 8 with 3 Routers & 3 Drills

Click on the link below to see the video of this machine running as of 07/20/2024

https://popvideo.io/view?v=1158196888

The descriptions are below the photos:

Twin Table machine with no post between the tables
Each Table is 63″ deep X 102″ wide.
Together you can machine a single part 63″ deep X 205″ wide,

You will have to zoom in on this one to see the heads.

3) Main heads are 12Kw or 16Hp with manual chucks that accept upto 3/4″ shank sizes
3) Piggy back Drills driven by electric motors and each has its own air actuated slide table for drilling holes, once in place.

Here is a view from the left side of the machine for a little closer view of the heads and how the control is situated.

The controller is a Fanuc 15MA
The flag ship product that was a major part of the Fanuc CNC Control family for over 35 years.
This control if purchased new with all the servo drives and motors would cost $50,000 or more.
All these parts are still available directly from Fanuc in several regional offices across the country.
Fanum will travel to your place to work on the control, drives and motors.
So you always have them as fantastic support both on the phone and in the field.

This is the Fanuc Control box that houses the servo driver cards and power supply.
The RS232 wire to load programs from DNC link to the office or laptop can be seen on the lower left hand side.

Follow the vacuum hose to the back wall to see the vacuum pump
vacuum pumps 15 hp CRS 65

15 HP Vacuum pump motor

Universal transformer to take most any line voltage you got to take to the proper machine voltage of 400 Volts.